HONEYSEW Neoprene Sewing Machine Motor Drive V Belt (MB-200(50teeth))

After searching several sites trying to find replacements for my Kenmore 158.18023 I decided to give these a shot. It's fits perfectly!

MB-390 ordered for full size vintage Singer models 15-90 & 237. Fits fine but will likely use it on the 237. Better to buy one of these toothed belts than the one size fits all round stretch belts. It is said those are hard on the motor. Took about 2 weeks to receive this belt. I think it will work just fine.

works good as replacement

I bought these belts to replace the drive belt on my table top mill. I don't do any heavy machining, nor do I do lot of it, but noticed last week that the belt had cracked in three places. In the middle of another job taking very light cuts in plastic, the belt started running sideways. On the last few cuts, half of the belt turned upside down. When I got the last cut done, I stopped the spindle and discovered that there was only one thread holding the whole thing together. I have a second belt but I am seriously considering throwing it in the trash and ordering a replacement from the manufacturer. Total run time on this belt was probably 24 hours since I installed it in January.

The machine belts did not fit. I purchased two on two occasions, but none fit........ I need a 96 teeth -19inch belt.

it worked

This belt was not quite what I expected. It is not flexible, so be sure the exact size ordered will fit your machine. I'm certain it will work correctly for what it's designed for.

No es lo que que promocionan es únicamente una bandita y bien pequeña por cierto 😠

Worked as expected.

Quality belt, but too small.

These are a good belt but I find the rubber a bit on the hard side

Appears to be good quality, but was too small

The size was not right